An easy to use Gel Graffiti remover with deep penetration and fast acting power for exterior surfaces. Elite Gel Graffiti remover penetrates and loosens spray paint graffiti and allows for easy removal of graffiti from the surface. It is effective at removing shadows or ghosting and continues to work well even when temepreturs fall below 5°c for long periods of time.

Elite Gel Graffiti remover can be used on masonry, brick, concrete, stone, mild steel, stainless steel, painted surfaces and wooden surfaces. (do not use on some plastics, galvanised metal surfaces or non-ferrous metal surfaces such as aluminium)

Exterior Graffiti removal process:

1. Put on your protective clothing, safety googles and gloves
2. Check the surface for excess dirt: The surface does not have to be perfectly clean but if there
   is a lot of traffic film, soot or substantial dirt, it is advisable to clean or power wash this off first.
3. Test a small hidden area prior to full application
4. Shake the product thoroughly to activate it and pour required amount into polypropylene container
5. Apply with brush or roller starting from the bottom up
6. wait about 90 seconds then pressure wash off
7.  repeat steps 4-6 if necessary

Equipment needed

1. Elite Gel Graffiti Remover
2. Safety equipment (chemical resistant gloves, goggles etc)
3. long handled roller with quality roller (re-usable if rinsed properly)
4. Polypropylene container for dispensing
5. If the surface is painted it is advisable to wet the surface before using Elite Winter
6. pressure washer: we recommend 2200 PSI pressure washer and cold water, in cooler temperatures hot water and higher PS1 may be more effective.

This product is for use by professional contractors only – this user guide should be read prior to using Elite Graffiti remover. The SDS sheet and User guide documents must legally be kept in the vehicle(s) and storage areas at all times.

Safety Precautions:

Use in a well-ventilated area. Avoid contact with skin or eyes. Wear chemical-resistant goggles or visor. Wear rubber (not PVC) gloves and overalls. Splashes to the skin should be washed off with plenty of water. In the event of eye contact, irrigate with clean water. For detailed health and safety information request a hazard datasheet.

Contact details: Lynn Gunter 07792 738831
Email: lynn@slsolutionsuk.co.uk

Elite Gel Graffiti Remove IS FOR PROFESSIONAL USE ONLY. NOT TO BE USED FOR ANY OTHER PURPOSE. NOT FOR RESALE. DO NOT MIX WITH ANY OTHER PRODUCT. TRIAL ON A SMALL INCONSPICUOUS AREA PRIOR TO FULL APPLICATION.

USE NEAT – DO NOT DILUTE
ONLY POUR THE REQUIRED AMOUNT INTO A POLYPROPYLENE

CONTAINER DO NOT POUR ANY UNUSED PRODUCT BACK INTO CONTAINER AS IT WILL CONTAMINATE THE REST OF THE PRODUCT

EVERY USER OF THIS PRODUCT SHOULD WEAR SAFETY GOGGLES, AND GLOVES AND CAREFULLY FREAD ALL APPLICATION AND SAFETY INSTRUCTION BEFORE USING

Ingestion: DO NOT induce vomiting, drink 1 – 2 glasses of water, seek medical attention

Skin Contact: Wash off immediately with plenty of soap and water, remove contaminated clothing, flush skin with running water. Seek medical attention if irritation or symptoms persist.

Eye Contact: Rinse continuously with water for at least 15 minutes, holding the eyelids open. Seek medical attention. If can be done easily done remove contact lenses.

Spills/leaks: Absorb on inert absorbent and transfer to a container. Prevent spillage from entering natural waters/land drains.

FIRE: Use water fog or fine water spray. Emergency workers to wear full protective clothing including breathing apparatus.

Emergency contact S & L Solutions (London) Ltd

Lynn: 07792 738831 or Steve: 07957 107467